Other products by AMERICAN TURBINE
Item #: SD-312
Our Price: USD $5,585.00
Quantity:
 

Description 



ADVANTAGES TO USING AMERICAN TURBINE’S SUPER DUTY JET

  • For boats up to 6500 pounds all up weight.

  • Engine and jet sit back as much as 8 inches farther back for more interior room.

  • Bearing housing held on with six bolts instead of four to better support the rear of the engine.

  • Completely sealed bearing housing water can’t come in around the driveshaft.

  • A larger thrust bearing 35% more load capacity.

  • Mechanical pump shaft seal never needs adjusting.

  • Stronger 17-PH stainless steel pump shaft.

  • Tapered wear ring for infinite adjustment.

  • Heat-treated aluminum impeller standard.

  • Secondary wear ring on the rear of the impeller to prevent bowl cavitaiton.

  • Jet will accept the 10” impeller.

  • Tandem lip seals on the bowl bearings, keeps grease in grit out.

  • Fifth generation bowl, better flow than any other mixed flow pump.

  • Nozzle inserts to fine tune your boat for optimum take-off, fuel economy and top speed.

  • Standard with Best nozzle, available HTR ll.

  • Highest static reverse of any mixed flow pump.

  • Transom flange cast into suction housing, no need to make plates.

  • Transom flange bolts to transom so the integrity of the transom is increased.

  • Water off-takes are piped through the transom flange with a hose barb requiring less rigging time.

  • Hand hole cover outside of transom for easier access.

  • Will not over heat your engine at an idle.




Share







Pin It

Email A Friend

Send your friend a link to this product.